Free call service for Baltimore City and County · How it works (410) 904-6168
Brick rowhouses on East Preston Street, where gaps at the foundation let rodents in

Learn · Updated November 3, 2026

Steel Wool vs Copper Mesh for Rodent Holes

Steel wool works for small gaps but can rust. Copper mesh does not rust and is easier to pack. For anything larger, use hardware cloth, sheet metal or mortar.

Both steel wool and copper mesh work for small rodent holes when packed tight and held in with sealant. The CDC recommends steel wool for small holes, with caulk or spray foam around it. University of California IPM notes that steel wool can rust over time. Copper mesh does not rust, so it often lasts longer in damp Baltimore cellars. For gaps larger than about half an inch, use hardware cloth, sheet metal, cement or mortar instead.

Why you need metal at all

Mice and rats gnaw. UC IPM says plastic screening, rubber, vinyl and expanding foam are ineffective for plugging holes used by house mice because mice chew through them. Nebraska extension says utility openings should be sealed tightly with metal or concrete, and that wood, plaster and caulk are less effective, though better than leaving a gap open.

Foam and caulk still have a job. They hold metal fill in place and close air gaps. On their own, they are not rodent barriers.

Steel wool: pros and cons

Steel wool is cheap, available at any hardware store and easy to stuff into small gaps around pipes. Rodents do not like chewing it.

The drawback is rust. UC IPM calls steel wool scouring pads good temporary plugs that may rust over time. In a damp cellar or outside, rust breaks the wool down and stains brick and siding. Soap-filled scouring pads are a poor choice since the soap washes out and leaves gaps.

Use coarse, plain steel wool, pack it tightly and cap it with sealant. Check it once a year.

Copper mesh: pros and cons

Copper mesh, sold in rolls for pest control, is a knitted copper fabric. It does not rust, so it holds up in wet spots like cellar pipe entries, around outdoor faucets and near downspouts. It is easier to cut, fold and pack into odd-shaped gaps than steel wool, and it does not shed fibers.

It costs more than steel wool, and like steel wool it works best when packed tightly and capped with sealant. Some stainless steel meshes do the same job.

For most Baltimore cellar pipe gaps, copper mesh is the better long-term choice.

Want a local rodent technician to look at it?Same-day appointments are often available.
(410) 904-6168

When neither is enough

Wool and mesh are for small gaps, roughly up to half an inch or so. For larger openings, the CDC recommends lath screen, metal, cement, hardware cloth or metal sheeting.

  • Gaps around large pipes or old abandoned lines: sheet metal collar or hardware cloth, fastened and sealed
  • Cracked or missing mortar: mortar patch
  • Holes in cellar walls or foundations: mortar or concrete
  • Old coal chutes and cellar window openings: sheet metal or masonry
  • Crawl space vents: quarter-inch hardware cloth
  • Door bottoms: metal-backed door sweeps

Rats are stronger chewers than mice, so rat holes need hard materials most of all.

How to pack a gap properly

  1. Clean loose debris and old caulk from the gap.
  2. Cut a piece of mesh or wool a bit larger than the gap.
  3. Pack it in tightly with a screwdriver or putty knife, deep enough that a rodent cannot pull it out.
  4. Cap the outside with a sealant, like silicone or polyurethane caulk, or a light layer of foam.
  5. For damp spots, use copper mesh and an exterior-rated sealant.
  6. Check the spot after a week or two for fresh gnawing or pulled fill.

See how small a hole a mouse can fit through for where to look.

What a technician will usually use

Most rodent technicians carry copper or stainless mesh for small gaps, hardware cloth and sheet metal for larger openings, and mortar or concrete patch for masonry. They cap mesh with an exterior-grade sealant. For cellar pipe entries in old Baltimore rowhouses, expect mesh plus sealant around small lines and a metal collar or mortar around large ones.

If you are comparing quotes, ask what materials each provider plans to use. A plan that relies on expanding foam alone is a warning sign. Ask whether the sealing is listed opening by opening, and whether a return visit checks the sealed spots for new gnawing.

Where to use each in a Baltimore rowhouse

Inside the kitchen and baths, around pipes under sinks and radiator lines, steel wool or copper mesh with caulk works well. In the cellar, use copper mesh around pipe entries and mortar for wall cracks. At the front wall under the stoop and the rear addition joint, use mortar or sheet metal. On doors, use sweeps. For a full walkthrough, read rodent-proofing a Baltimore rowhouse, or have a technician do it through rodent exclusion.

Want a technician to seal it?Same-day appointments are often available.
(410) 904-6168

Questions

Common questions

Is copper mesh better than steel wool for mice?

For long-term use, often yes. Copper does not rust, so it lasts longer in damp spots. Steel wool works but UC IPM notes it may rust over time.

Can mice chew through steel wool?

Mice avoid chewing it, but loose or rusted steel wool can be pulled out. Pack it tightly and cap it with sealant.

Does spray foam stop mice?

Not by itself. Mice gnaw through foam. Use it to hold metal fill in place, not as the barrier.

What should I use for large holes?

Hardware cloth, sheet metal, cement or mortar. The CDC lists lath screen, metal, cement, hardware cloth and metal sheeting for larger holes.

Where can I buy copper mesh?

Hardware stores and home centers usually stock copper mesh in the pest control or weather stripping aisle, sold in rolls. Stainless steel mesh made for rodent sealing works the same way.

Free call, no obligation

Call and describe your rodent problem

Say whether it is rats or mice, what kind of building it is and how long it has been going on. Your call goes to an independent local rodent control provider, who gives you the price before any work starts.

Same-day appointments are often available

Call (410) 904-6168